The maximum working load (MWL) for the 50.2 ST Radial Winch is 1450 Kg (3196 lb) Subjecting the winch to loads above the maximum working load can cause the winch to fail or pull off the deck suddenly and unexpectedly during high loads causing severe injury or death. Radial Winch 50.2 ST EL/HY5 Installation and Maintenance Manual - Mod.F
Radial Winch 35.2 ST - Mauri ProRadial Winch 35.2 ST 10 Installation and Maintenance Manual Carry out Procedure 1 as shown in the paragraph on winch installation and then do the following:6. Completely unscrew the three screws n°27 8. Slide out the central shaft n°19 10. Remove the drum support n°15 Important:washer n°12 may remain inside the drum support! 7.
Radial Winch 40.2 ST 8 Installation and Maintenance Manual B. Remove the winch and drill the five 6.2 mm diameter holes. C. Bolt the base of the winch to the deck using five M6 Socket Head (SH) bolts for Procedure 1 or five hexagonal headed M6 bolts for Procedure 2 (neither is Installation and Maintenance ManualRadial Winch 50.2 ST E/HY 11 Installation and Maintenance Manual 1. Position the flange (see Page 12) 3. Position the reduction gear and motor 2. Tighten the six screws ( 8 Nm/ 71 in-lb) 4. Tighten the two screws ( 8 Nm/ 71in-lb). Be sure to align the flange. F. Reassemble the winch following the steps in Procedure 1 or Procedure 2 in the reverse order,